Q7 3.0T Premium Plus
3.0L 6-Cylinder · 125,000 mi · Model only
4.5 researched
Research covers this year, model and mileage. Items marked addressed are reported by the owner and not verified by Squeezed. This is not a substitute for a pre-purchase inspection.
2017 Audi Q7 3.0T Premium Plus
This 2017 Audi Q7 3.0T has a supercharged engine with known cooling system and PCV failures. At 125k miles, expect to replace the water pump, thermostat, and PCV, and clean the intake valves. The supercharger intercooler bricks can leak coolant into the engine — a critical issue. The price is reasonable, but budget at least about $6,200 for immediate service.
Deal Score weighs the asking price against comparable listings, the title, and the repairs documented in this guide.
- Price 9% below market
- Weak reliability (4.5/10)
Red flags
- High Mileage
125k miles, major service items likely due
- No Service Records Provided
Maintenance history unknown, verify all major service
- Supercharged Engine
Known for water pump and thermostat failures
- Boise, ID Location
Extreme temperature swings, check cooling system integrity
Green flags
- Premium Plus Trim
Adds luxury features like panoramic sunroof and leather seating
When this car gets expensive
The chance of a major repair as the miles add up. This one is at 125k, before the climb starts around 140k.
What’s costing this car points
Fixing these, or marking them done, raises the score.
- −1.7
Supercharger Intercooler Brick Leak
Usually shows up around 80k mi - −0.4
Timing Chain Tensioner Wear
Usually shows up around 100k mi - −0.2
Water Pump Leak
Usually shows up around 60k mi - 7 smaller items−0.2
Detailed findings, 10 items
Open a card for the full breakdown. Items the owner handled show as checked.
Reflects the open findings; items the owner handled are excluded.
Check these before you buy. A clean check clears the car.
Supercharger Intercooler Brick Leak
The supercharger intercooler bricks can develop internal leaks, allowing coolant to enter the intake manifold. This can cause white smoke, misfires, and potential engine damage. It's a known issue on the 3.0T supercharged engine.
Costly repairs. Price them in and use them to negotiate.
Water Pump Leak
The water pump on the 3.0T supercharged engine is prone to leaking coolant, often from the shaft seal. This can cause overheating and coolant loss. At this mileage, it's highly likely to have been replaced or will need replacement soon.
Thermostat Failure
The thermostat often fails along with the water pump, leading to incorrect engine temperature readings and potential overheating. It's common to replace both at the same time.
PCV Valve Failure
The PCV (Positive Crankcase Ventilation) valve/oil separator can fail, causing vacuum leaks, rough idle, excessive oil consumption, and check engine lights. It's a known weak point on this engine.
Timing Chain Tensioner Wear
The timing chain tensioner on the rear of the engine can wear over time, causing a rattling noise on cold start. If not addressed, it can lead to timing chain stretch or failure. At 125k miles, this is a concern.
Minor wear for the car’s age. Worth tracking, not negotiating.
Carbon Buildup on Intake Valves
Direct injection engines like the 3.0T are prone to carbon buildup on intake valves. This can cause rough idle, misfires, and reduced performance. Cleaning is recommended every 60,000-80,000 miles.
Engine Mounts Worn
The hydraulic engine mounts can leak fluid and collapse, causing excessive vibration, especially at idle. At 125k miles, they may be worn.
Control Arm Bushing Wear
The front control arm bushings can wear out, causing clunking noises and uneven tire wear. This is common on heavy SUVs at this mileage.
Oil Consumption
Some 3.0T engines have reported higher-than-normal oil consumption. This could be due to worn piston rings or PCV failure. Inquire about oil consumption levels.
Transmission Fluid Service
The ZF 8-speed transmission should have fluid and filter changes every 60,000-80,000 miles for longevity. At 125k, it's likely overdue if not done.
Every finding still open carries a question worth asking. Copy them as one message, already ordered by severity. Anything you have marked above drops off on its own.
Price & negotiation
BetaBased on comparable listings and the repairs you can document. A starting point for what this car should cost.
Price breakdown
What it costs, and when
Verify now
Critical and major items to confirm first.
Possible year-one expense
Caution items with repair-cost context.
Watch later
Lower-confidence or no-cost items to monitor.
Each range is what that one item costs if it turns out to be present. Not every item will apply to this car, so they do not add up to a bill. Verify with a mechanic.
Asking is $15,000 against a typical $16,500 for this car and mileage. The work is the difference, not the sticker.
Negotiate your offer
Asking is about 9% below the market estimate, so there may be less room to move. The documented repairs below are still relevant to raise.
- Documented critical/major repairs of $4,900–$7,400 you can point to.
- Strongest items to raise first: Timing Chain Tensioner Wear, Supercharger Intercooler Brick Leak.
Pricing is in beta. The market estimate comes from research models and can be off by thousands on the same car, so check recent local listings before you rely on it. This is information to help you research, not a professional inspection, an appraisal, or financial advice.
Recalls & safety
NHTSA crash-test ratings and recall data for this make, model, and year. Check recall status with your VIN before buying.
In-person inspection
10 things to check before you buy
4 major and 5 caution findings, turned into a walkthrough for the driveway. Answers save as you go.
Before you leave: Ask the seller not to start or move the car before you arrive. A sales-ready car has usually been warmed up, and a warm engine hides the startup smoke, rattles and rough idle that the first section is built around.
01Cold Start CheckFirst1
Start the engine cold while you watch the exhaust and listen. Note how quickly it catches, the tint of any smoke, rattles in the first few seconds, and how smoothly it settles into idle. This is the one test you cannot repeat on the spot.
02Engine & Systems5
Before the first start: pull the oil dipstick and look for a milky film, check the coolant for oil or rust, squeeze the radiator hoses for hard or mushy spots, and note the battery date. Once warm: confirm the cooling fans cycle, listen for belt noise, look for fresh seepage that was not there cold, and check that the A/C blows cold.
03Test Drive2
Drive a route with stops, a hill, and some open road. Feel for shift quality, clutch or torque-converter behaviour, brakes that pull or pulse, steering play, and any noise that changes with speed or steering angle.
04Documentation2
Match the VIN across the title, dash, and door jamb. On a dealer lot, read the Buyers Guide sticker: it states whether the car carries a warranty or is sold as is, and as is means every repair after the sale is yours. Review service records and recall history, then run an OBD-II scan for stored and pending codes.
Everything on this list is what you can see standing next to the car. A shop on a lift sees the rest, and a written pre-purchase inspection listing parts and labor is what a seller has to answer to. Budget roughly $100 to $150 at an ASE-certified shop.
Get your own Buyer Guide
Same depth of analysis, personalized to the exact vehicle you're evaluating. Known failure patterns, repair cost exposure, and questions to ask the seller.
